SDK User Guide

This page lists articles that provide an overview of the SDK, and allow you to see some concrete examples of its use.

If you are completely new to Eyes then we recommend you read that articles in the Overview, in particular: the following pages are a good step by step introduction to the basics of writing an Eyes visual test:
  • How to group tests into batches using the SDK

    This article describes how to use the eyes$setbatch$mOrP in the Eyes SDK to define that the results of multiple tests should be grouped together in the Test Manager.

  • The Eyes SDK check Fluent API

    This overview presents a high level overview of the Fluent API used with the eyes$check methods. In this overview you will be introduced to all the available methods implemented by this API and how they can be used together to create and configure your checkpoints.

  • Test suite configuration

    This article presents some key configuration values, that are normally set once per test suite to customize Eyes to the test environment.

  • Visual Grid configuration

    This article describes how to configure the Visual Grid, including: defining which browser configurations should be rendered, and setting the baseline environment.

  • Migrating code to use the Visual Grid

    This article describes how to change code written before the Visual Grid was available, to use the Visual Grid compatible components.

  • Visual locators

    This article describes how you can use Eyes to find the position of visual entities on your page. You can use this to trigger instead of using DOM based locators.